Assembly - GOK SmartBox 4 Montage- Und Bedienungsanleitung

ASSEMBLY

Before assembly, check that the product is complete and has not suffered any damage during
transport.
ASSEMBLY must be carried out by a specialised company.
The specialised company and the operator must observe, comply with and understand all of
the following instructions in this assembly and operating manual. For the system to function
as intended, it must be installed professionally in compliance with the technical rules
applicable to the planning, construction and operation of the entire system.
These regulations also include the accident prevention regulations of the employers' liability
insurance associations, the VDE regulations, and the installation and operating instructions.
The housing of the display unit is suitable for wall mounting and is connected to
the 230 V mains supply. Under normal circumstances, the display unit must be operated with
the housing cover closed.
It is installed and started up by a qualified technician while the unit is open.
Selecting an installation location / Checking the reception quality of the mobile phone
network
Before installing the SmartBox
applicable telecommunications network is sufficient. The easiest way to do this is to have a
mobile phone ready at the designated place of installation. As a precondition, the mobile
phone must be registered with the same telecommunications network (in Germany e. g. T-
Mobile, Vodafone, O
If there is no suitable mobile phone at hand, you can also perform the test with the SIM card
®
. In this case, insert this activated SIM card into a mobile phone and switch
for the SmartBox
it on again.
The reception quality at the designated place of installation can simply be seen from the
indication in the mobile phone screen. At least one bar/scale line of the reception quality
indicator must be visible on the screen. If the reception quality is very bad (no bar/scale line
visible), another installation site should be picked and tested (possibly in another room).
If the reception quality is very bad, an additional antenna (accessory) should be used. It can
be installed e. g. in front of a basement window.
Installing the level probe
See assembly and operating instruction "Level probe".
Installing the probe
See assembly and operating instruction
„FSA-W 4-20 mA level gauge for SmartBox
ELECTRICAL INSTALLATION see corresponding instruction
„FSA-W 4-20 mA level gauge for SmartBox
part no. 28 400 57 c
®
, you must check whether the reception quality of the
) as the SIM card which is used for the SmartBox
2
®
SmartBox 4 / SmartBox
®
1 – 4".
®
1 – 4".
®
4 PRO
®
.
5 / 32