Assembly - GOK VSR 0126 Montage- Und Bedienungsanleitung

Outlet, optional
All G. and H. connections according to EN 16129. Other connections may also be used.

ASSEMBLY

Before assembly, check that the product is complete and has not suffered any damage during
transport. ASSEMBLY must be carried out by a specialised company.
The specialised company and the operator must observe, comply with and understand
all of the following instructions in this assembly and operating manual. For the system
to function as intended, it must be installed professionally in compliance with the technical
rules applicable to the planning, construction and operation of the entire system.
Screw connections
If connections leak, there is a danger of explosion, fire or suffocation!
Gas may escape if the product is turned.
Do not turn the product after it has been installed and the connections have been
tightened.
Tighten connections only when they are not pressurised.
Risk of injuries due to blown-out metal chips!
Metal chips may cause eye injuries.
Wear safety goggles!
Assembly notes
Malfunctions caused by residues! Proper functioning is not guaranteed.
• Visually check that there are no metal chips or other residues in the connections!
• It is important that metal chips or other residues are blown out!
Install with suitable tools, if required.
Regarding screw connections, use a second spanner to brace against the connection
nozzle. Do not use unsuitable tools, such as pliers.
Install the pressure regulator so that it is not under tension.
Use the regulator support.
Product damaged through incorrect installation direction
Proper functioning is not guaranteed.
• Observe the installation direction (marked on the product with an arrow
Artikel-Nr. 01 267 50 d
Trading name and dimensions
acc. to standard
Screw-in connector
• H.22 = G 1/4, G 3/8, G 1/2, G 3/4 or G 1
• For a screw-in connector with O-ring
Compression fitting
• H.8 = compr. fit 12, compr. fit 15, compr. fit 18,
compr. fit 22, compr. fit 28, compr. fit 35
• H.9 = compr. fit 8, compr. fit 10
Mitteldruckregler Typ VSR 0126
Installation
notes
).
15 / 64