Examples For Programming - GOK SmartBox 4 Montage- Und Bedienungsanleitung

Menu
7.Exit
 SmartBox 4
®
PRO
8.Exit
After performing entry steps 1 - 7, the programming process is completed.
After confirmation of step "8.Exit", the device automatically returns to default display mode;
the current tank content is shown in the display.
Special functions are available under entry steps 9 to 24.
After the end of setup, do not forget to replace the housing cover!
After completing the ASSEMBLY and PROGRAMMING, carrying out a function check is
recommended (FUNCTION CHECK section).

EXAMPLES FOR PROGRAMMING

Example 1: Basement tank for 6,000 litres heating oil, linear steel tank
Inner height 165 cm, (fill level 125 cm)
SmartBox
Step
PIN
1.Measure probe
2.Liquid
3.Tank shape
4.Tank volume
5.Tank height
5b.Filling limit
6.View  View details
7.Relay
8.Exit
 press [Enter] to see the indication
16 / 32
Input function
Example of switch point setting for Active (with
hysteresis):
Enter switching points as % values from 01 - 99 (and/or
enter as °C value from -99 to +99 only for probe with
temperature measurement)
deactive  activate with [+] / [-] to
active  press [Enter] to confirm 
On 10%  ON: set with [+] / [-]  [Enter]
Off 12%  OFF: set with [+] / [-]  [Enter]
On +0°C
 ON: set with [+] / [-]  [Enter]
Off +0°C  OFF: set with [+] / [-]  [Enter]
Deactivate the relay via deactive or input of 0% or
0°C (for On and Off).
Press [Enter] to return to display mode
Press [Enter] to return to display mode
®
4 with standard levelprobe 0 - 250 mbar
SmartBox
Entries / selection
PIN: 0000
250mbar
Heat.oil
Linear
6.000L
165.0cm
95%=157cm
Fillspace+Percnt
(2st line of the display set with [+] / [-] keys)
Deactive
Heat.oil 4.550L
-1.150L
®
4 / SmartBox
Input value
ON ______%
OFF ______%
ON ______°C
OFF ______°C
(set with [+] key 
press [Enter] to save)
(set with [+] / [-] keys)
(set with [+] / [-] keys)
(set with [+] / [-] keys)
76%
part no. 28 400 57 c
®
4 PRO