Assembly - GOK Caramatic BasicControl Montage- Und Bedienungsanleitung

ASSEMBLY

Before assembly, check that the product is complete and has not suffered any damage during
transport.
Installation of the information and control unit (control panel)
1. Remove the product from the box and break down into individual parts (cover socket,
front panel with circuit board and cover frame). A surface-mounted socket is not
included in the delivery.
2. Wherever possible, designate the installation location for the control panel in a clearly
visible and accessible location and on a flat and smooth surface. To do so, make a
Ø 55mm cutout. Avoid supporting structures in the wall for safety reasons.
3. Mark four holes for the screws through the front panel.
4. Guide the 10-pin connector
CONNECTION on pages 7 and 8) into the cutout from behind and connect it to the
10-pin header on the circuit board for the control panel.
5. Attach the cover socket to the front panel of the control panel, taking care to ensure that
the groove for the cable is in the right place.
6. Place the cable in the groove in the
cover socket and fix it with the
cable tie included (tighten the cable
tie and remove the protruding end).
7. Next steps: see under ELECTRIC
CONNECTION.
Artikel-Nr. 71 392 50
with connection cable
Caramatic BasicControl
+ (see ELECTRICAL
17 / 24