Programming - GOK SmartBox 4 Montage- Und Bedienungsanleitung

PROGRAMMING

Overfilling of the tank due to incorrect entry values.
Operating media may leak. These:
• are hazardous to water,
• are category 1,2 and 3 inflammable liquids,
• can ignite and cause burning,
• may cause falling injuries due to slipping.
Enter these values with care!
The entry values are also retained in the event of the failure of the supply voltage.
Programming the level gauge
Before programming, you need to ascertain the tank data and enter the values into the right
column (Input value) of the following table. Then, enter the values for the individual entry
steps.
Setting a
parameter:
Quitting the
setup mode:
12 / 32
Press [ENTER] to open setup mode.
Select the desired setting parameter via [PLUS].
Press [ENTER] to call up the value selection for the parameter.
Set the value with [MINUS]/[PLUS], press [ENTER] to save.
You can quit the setup mode at any time.
Select "Exit" and press [ENTER]
 to go back to the standard display mode.
®
SmartBox 4 / SmartBox
®
4 PRO
part no. 28 400 57 c