Assembly - GOK NDR 0515 Montage- Und Bediensungsanleitung

Other
connections

ASSEMBLY

Before assembly, check that the product is complete and has not suffered any damage during
transport. ASSEMBLY must be carried out by a specialised company.
See USER QUALIFICATION! The specialised company and the operator must
observe, comply with and understand all of the following instructions in this assembly
and operating manual. For the system to function as intended, it must be installed
professionally in compliance with the technical rules applicable to the planning, construction
and operation of the entire system.
Examples of applications
Tank system according to A3 B3/4 for
outdoor installations "f"
Risk of asphyxiation from gas leaks in enclosed spaces.
High concentrations of gas can cause difficulty in breathing and lead to unconsciousness.
A discharge line
Screw connections
If connections leak, there is a danger of explosion, fire or suffocation!
Gas may escape if the product is turned.
Do not turn the product after it has been installed and the connections have been
tightened.
Tighten connections only when they are not pressurised.
Risk of injuries due to blown-out metal chips!
Metal chips may cause eye injuries.
Wear safety goggles!
Artikel-Nr. 05 151 50 h
Trading name and dimensions
acc. to standard
Test connector
• 9 mm nozzle
• with set screw
Test connection for medium pressure range
• Compression fitting size 12
• to check the pressure on the inlet side
must be connected from the breather on the product to outdoors.
Tank system according to A4 B3/4-t for
indoor installations "t"
NDR 0515 / NDR 0516
Installation
instructions
First, loosen the
set screw with a
screwdriver, then
attach the test
hose.
Use a spanner to
remove the screw
connection. Attach
the test hose.
19 / 108