List Of Commands - GOK SmartBox 4 Montage- Und Bedienungsanleitung

Alarm
The status of the alarm input (DIGITAL INPUT) is reported in plain text, e.g.:
• kein Alarm (no alarm)
• Alarm 1 Anlagenstörung  the text Anlagenstoerung (Facility failure)
• Alarm 1 OK
• Alarm Tank n
• Alarm Tank n OK
• Temp-Alarm n
• Temp-Alarm n OK
Credit or
The credit remaining on a prepaid card is indicated if the service provider
SMS allows this function (USSD process). In Germany this is possible in the T-
counter Mobile, Vodafone and O
no sense; for them, an SMS counter should be activated, see #G=.
Relais
Rel=0  Relay OFF ; Rel=1  Relay ON  only SmartBox
Error
Command error: - The SMS only shows this element if an error is pending -
The SmartBox has received a command that is invalid and cannot be
processed. Check the format of command  see List of commands
Example Ct-024 Tankmonit. K. Miller, Levenham Rd.21; Tank filling 2;
message 33%=1600L, 40%=40.00, 100%=99.99; no alarm; 14.81 £, Rel=0

LIST OF COMMANDS

The commands to the SmartBox are sent automatically if the www.smart-inspector.com
system is used. Alternatively, they can be sent manually via SMS from a mobile phone.
All commands start with the # character (command character).
Comm- Parameter
and
#T=
Mobile network
number for the
SMS messages
#TA1=
1. Mobile phone
(identica
number for
l to
alarms
#TA=)
#TA2=
2. + 3. Mobile
...
phone number
#TA3=
for alarms
#Q=
part no. 28 400 57 c
can be changed (Command #A1)
 OK report, i.e. alarm 1 has been cancelled
 Tank display device n reports a fault or an
alarm
 OK report; i.e. the fault/alarm has been
cancelled
 Tank n has fallen below the set temperature
 OK report; i.e. the temp alarm from tank n has
been cancelled
networks. For contract cards, this function makes
2
Description
Mobile phone number to which the
automatically generated reporting SMS are sent
(e.g. building supervisor, headquarters)
1. Mobile phone number for a fault mobile
phone. If for #TA1=... an alarm number is
entered, the alarm SMS is sent to this number
(approx. 5-minute delay).
If no number is entered (field empty), the report
is sent to the #T number.
2. + 3. Mobile phone number for a fault mobile
phone. The current alarm is reported to this
number as 2. / 3. (for delay time, see command
#Q= ) If this alarm number is not entered
(empty), this means that the end of the alarm
chain has been reached and that there are no
further messages for this alarm.
Change the delay time for the alarm chain, e.g.
#Q=10 sets the delay time to 10 minutes.
®
SmartBox 4 / SmartBox
®
4 PRO
®
4
Standard /
default value
If Smart-
Inspector
connection
exists, this
field is empty
If Smart-
Inspector
connection
exists, this
field is empty
20
[1...255]
23 / 32