Assembly - GOK FL 90-4 Montage- Und Bedienungsanletung

ASSEMBLY

Before assembling, check that the product is complete and has not suffered any damage
during transport.
ASSEMBLY has to be carried out by a specialised company.
For the system to function as intended it must be installed professionally in compliance with
the technical instructions applicable to the planning, construction and operation of the entire
system.
NOTE
Malfunctions caused by residues.
Proper functioning is not guaranteed.
Visually check that there are no metal filings or residues in the connections.
It is important that metal filings or other residues are blown out.
Tool
Assemble only with a suitable open-end spanner. Always brace against the
connection bracket. Do not use any other tool.
NOTE
Product damaged through incorrect installation direction.
Proper functioning is not guaranteed.
Check the installation direction
Screw connections
WARNING
If connections leak, there is a danger of explosion, fire or suffocation.
Gas may escape if the product is turned.
Do not turn the product after it has been installed and the connections have been
tightened.
Tighten connections only when they are not pressurised.
6 / 12
Low pressure regulator Type FL 90-4, Type FL 91-4
on the product housing.
Part No. 05 004 52 a