Programming The Remote Monitoring Functions - GOK SmartBox 4 Montage- Und Bedienungsanleitung

PROGRAMMING THE REMOTE MONITORING FUNCTIONS

If the device is linked to www.smart-inspector.com, this is done via the Internet.
As an alternative, the setting parameters for remote monitoring functions of the SmartBox
can also be transmitted via SMS by any mobile phone. This can be done directly on site or
optionally at a later time, e.g. from the company headquarters.
Command to the device (from a mobile phone)
• An SMS may contain one or several commands.
• However, the total length of the SMS must not exceed 80 characters.
• There must be no spaces between the SMS commands and no special characters!
• When entering a chain of commands, the commands #R or #M or #C must come at the end,
if applicable.
Setting the SMS target number (number of the receiving building supervisor):
• Enter the SMS text ... #T=01701234567#M (i.e. the number of the reporting mobile phone)
• ... and send it the mobile network number of the SmartBox
• Because of #M, the SmartBox
®
• The SmartBox indicates reception of this SMS by showing "Receive" in the display.
• The transmission of the reporting SMS is indicated by showing "Sending" in the display.
Setting of unit names for the text messages of the system
• Enter the SMS text #H=Tankmonitoring Jones NameofPlace #R
• ... and send it the mobile network number of the SmartBox
• Commands as #T=... #H=... and #R can be sent as a chain in one single SMS.
Example: Complete setup by means of one single SMS containing a chain of commands
#T=01714901312#H=Ct-024Tankmonit.K.Miller,LevenhamRd.21#P=10,07,15,01#R
See page 18 for a list of all commands.
Messages from the SmartBox
General, there are two ways to receive fill level measurements or other data from the
®
SmartBox :
1. Manual
inquiry
2. Automatic
messages
part no. 28 400 57 c
®
will send an SMS in reply (possibly after 1 - 2 minutes' wait).
®
Data from the SmartBox
To do so, simply send an SMS with a brief command, e.g. #R, to the
mobile phone number of the SmartBox
your mobile phone will receive the answer SMS with the data on tank
content(s). In addition to fill level measurements, configuration data of
®
the SmartBox can be queried as well.
®
The SmartBox can send various messages automatically to the
www.smart-inspector.com system, to a (monitoring) mobile phone, or
to an E-mail address. The following messages are available.
SmartBox
®
.
®
.
®
can be queried through any mobile phone.
®
. After approx. 2 - 3 minutes,
® ®
4 / SmartBox 4 PRO
®
21 / 32