Assembly - GOK VSR 0523 Montage- Und Bedienungsanleitung

Outlet, optional
The G 3/4 coupling nut version can be used only in combination with the GOK
separation connector (e.g. solder/separation connector Type LTV or compression/separation
connector Type PTV).
All G. and H. connections according to EN 16129. Other connections may also be used.
Other
connections

ASSEMBLY

Before assembly, check that the product is complete and has not suffered any damage during
transport.
ASSEMBLY must be carried out by a specialised company.
The specialised company and the operator must observe, comply with and
understand all of the following instructions in this assembly and operating manual. For the
system to function as intended, it must be installed professionally in compliance with the
technical rules applicable to the planning, construction and operation of the entire system.
22 / 120
Trading name and dimensions
acc. to standard
Compression/separation connector
• Thread optionally G 3/4, G 1
• Nominal size optionally 12 mm, 15 mm,
18 mm, 22 mm,
Screw-in connector
• H.22 = G 1/4, G 3/8, G 1/2, G 3/4 or G 1
• For a screw-in connector with O-ring
Compression fitting
• H.8 = compr. fit 12, compr. fit 15, compr. fit
18, compr. fit 22, compr. fit 28, compr. fit 35
• H.9 = compr. fit 8, compr. fit 10
Solder/separation connector
•H.10 = Thread G 3/4 or G 1
• Diameter 10 mm to 28 mm
Ball-cone connector
• H.6 = Thread G 3/8 lh M
Trading name and dimensions
acc. to standard
Emergency supply connector with non-return
valve
• Thread G 3/8 lh M
• according to EN 16129
Test connector
• 9 mm nozzle
• with set screw
Installation notes
Spanner sizes
G 3/4 = width 30
G 1 = width 38
Hexagonal
Torque:
G 3/8 = 15 Nm
Installation
instructions
See emergency
supply connector
option
First, loosen the
set screw with a
screwdriver, then
attach the test
hose.
Artikel-Nr. 05 239 50 l