GOK SmartBox 4 Montage- Und Bedienungsanleitung Seite 54

Event causing the message
The following events cause a message to be sent:
Message text
Info
Info Tank 2
Tank filling
2
Manually
inquiry
Limit Tank 3
New tank 2
Alarm 1
Check credit
Test
Parameter
Relais on
Relais off
When two events are pending at the same time, the major of the two events is reported in the
SMS first (e.g. Alarm 1 before Limit Value Tank 1).
Form of the SMS messages sent by the unit
An SMS message takes the following form:
Header; reason for the message; tank content(s); alarm status; credit/SMS counter;
relay status
Header
Freely selectable text.
This header text is sent as the first part of each reporting SMS message.
It should e.g. contain the customer's number and address etc.
Example: Ct-024 Tankmonit. K. Miller, Levenham Rd.21
Reason for
Info; Grenzwert Tank x; Betankung tank x; see table above
the message
Tank
The contents of tanks 1 - 4, if applicable, are mentioned successively in the
content message text. Example: 100%=9999L, 100%=10.00, 74%=29.65.
In each case, the percentage and the current liter value is given.
Liter values exceeding 9999 l are given as a numerical value with decimal
place(s), but without unit, e.g.: 10,00 (cubic meters) or 29,65 (cubic meters)
If ???? is reported for a tank, this tank does not provide any current values
(the SmartBox gets no more data from the additional indicator).
22 / 32
Reason for the message
Cyclical message after n days or after x% reduction of fill level
Message at start of fueling process (low level)
Message after fueling, as high-level message, is given approx. 60 min.
after start of fueling process
Manual system inquiry via SMS command #R or #M
Limit Value Tank 3 - value for tank n has fallen below set message
threshold
New tank indicator for tank 2 has been activated/connected
Signal at alarm input (DIGITAL INPUT), e.g. unit malfunction
Check credit - the credit on the SIM card has fallen below 1 €. Please top
up the credit! (in Germany the credit message only works in the T-Mobile,
Vodafone, O networks)
2
In the menu item 15.Modem, you can cause the unit to send an SMS by
selecting "Send SMS" (+ENTER)
Query of the unit settings (configuration) by SMS command #C
This is displayed when the device relay has switched over
 only with SmartBox
 Relay 'Activ' is set or #S=2
 Relay 'Activ'+SMS' is set or #S=21
SmartBox
®
4  Conditions: Menu step 7
® ®
4 / SmartBox
part no. 28 400 57 c
4 PRO