Installation Of New Cell Assembly - Stryker XPRT Bedienungs- Und Wartungshandbuch

CELL ASSEMBLY REPLACEMENT KIT (CONTINUED)
8 . Return head end support surface back to original flat position .
Note: Two people required to return support surface to original flat position .
9 . Unsnap cell-retaining strap from cell assembly near foot end as shown in Figure 6 .
10 . Remove Cell Assembly and contact your local Stryker service representative to return for fault evaluation .

INSTALLATION OF NEW CELL ASSEMBLY

1 . Place new cell assembly on top of foam crib . Refer to Figure 7 .
2 . Snap retaining strap to new assembly . Refer to Figure 6 .
www.stryker.com
Service Information
Figure 6
Figure 7
2950-109-005 REV B
Return To Table of Contents
1-51
English