Service Information; Caster Assembly Replacement - Stryker 1089 Wartungshandbuch

CASTER ASSEMBLY REPLACEMENT

Tools Required:
• 1/2" Socket
• 3/8" Drive Ratchet
• Needle Nose Pliers
• Bungee Cords
• Small Bottle Jack
• 3/8" Drive Torque Wrench (ft-lb)
Procedure:
1 . Pump the stretcher all the way up .
2 . Raise both siderails to the up and latched position .
3 . Using bungee cords, support the raised base hood .
4 . Put the base brake/steer pedal in the neutral position .
5 . Using a 1/2" socket, remove the two flange nuts (one on each side) that secure the timing link to the casters .
6 . Using needle nose pliers, remove the rue clip and then the clevis pin from the brake rod activator .
7 . Apply the brakes by moving the brake/steer pedal to the brake position .
8 . Remove the brake timing link assembly by equally pulling outward on the timing link assembly . Save the brake
timing link for reinstallation .
9 . Using a small bottle jack, raise the stretcher up until the caster falls out of the frame socket . Discard the caster .
10 . Install the new caster assembly by carefully and slowly lowering the jack down until the caster is secured in the
base frame, and then remove the jack .
Note: Make sure that the arrow located at the top of the caster assembly fork stem points toward the foot end of the
unit . If the arrow does not point toward the foot end, damage could occur to the caster assembly .
11 . Reverse steps to reinstall . Torque the two flange nuts that secure the timing link assembly to the casters to 80 ±
20 ft-lb .
Note: When installing the new brake timing link assembly be sure to reinstall the bushing which may have fallen off
during the removal of the old brake timing link assembly .
12 . Verify proper operation of the unit before returning it to service .
www.stryker.com

Service Information

1089-009-006 REV G
Return To Table of Contents
1-15
English