Service Codes - Stryker XPRT Bedienungs- Und Wartungshandbuch

English

SERVICE CODES

Note:
• Primary wire color is referenced first and the stripe color is referenced second . For example, white/orange is a
white wire with an orange stripe .
• Disconnect connector from the PC board during cable continuity tests . Never insert meter leads or anything else
into the connector pin receptacle and check continuity at the access slot on the side of the connector .
Service Event
Pendant_Disconnected
CPR_Left
CPR_Right
CPR_Both
Return To Table of Contents
1-58
Service Information
Code Description
65 No heartbeat between the touch
screen and the head box control .
PCB communication .
Headbox beeps during disconnect .
Possible installation procedure was
not followed and support surface
was powered up without display
connected .
Suggest reset service log and monitor
for additional error 65 .
Proceed to troubleshooting if multiple
errors are logged .
66 Left CPR plug is not detected .
67 Right CPR plug is not detected .
68 Both CPR plugs are not detected .
2950-109-005 REV B
Problem Area
1 . Check black cable connector is
secure and twist locked .
2 . Check wire continuity of all black
cable wires from foot box PCB to
display PCB .
3 . Check blue cable
white/blue and blue/white wires for
continuity from foot box to head box .
4 . Check yellow cable clear wire for
continuity from foot box to head box .
1 . Check CPR plug on patient left side is
fully engaged and snapped .
2 . Check blue wires are connected to
common and normally open contacts
of CPR switch in head box .
3 . Check for switch continuity between
blue wires when plug is engaged .
4 . Check connector is fully engaged to
head box control PC board TB6 .
1 . Check CPR plug on patient right side
is fully engaged and snapped .
2 . Check violet wires are connected to
common and normally open contacts
of switch .
3 . Check for switch continuity between
violet wires when plug is engaged
4 . Check connector is fully engaged to
PCB TB6 .
1 . Check CPR plugs are fully engaged
and snapped .
2 . Check connector is fully engaged to
PCB TB6 .
white/orange,
www.stryker.com