Bed Pan Placement; Bed Pan Removal; Incontinence / Drainage - Stryker XPRT Bedienungs- Und Wartungshandbuch

English

BED PAN PLACEMENT

1 . Level the bed .
2 . Lower the siderail on the caregiver's side .
3 . Use the TURN ASSIST feature (Refer to "To Start Turn
Assist" on page
4 . Position the bed pan on the support surface .
5 . Return the patient to the center position and be sure
the bed pan is properly positioned under the patient .

BED PAN REMOVAL

1 . Level the bed .
2 . Lower the siderail on the caregiver's side .
3 . Use the Turn Assist feature (Refer to "To Start Turn
Assist" on page
4 . Remove the bed pan from the support surface .
5 . Return the patient to the center position .
6 . Position the patient along the center
line of the support surface .
WARNING
Failure to position the patient along the support surface center
line before starting therapy could result in patient injury . Check
patient frequently to ensure proper positioning and support
surface inflation .
7 . Align the patient's shoulders with the graphic
indicator on the side of the support surface .
8 . Raise and lock the siderails .

INCONTINENCE / DRAINAGE

A single layer of moisture vapor permeable or incontinence
pads may be used . However, using too many layers between
the patient's skin and the support surface will reduce the
effectiveness of the pressure-relieving capabilities of the
system .
Watch for incontinence or drainage and provide appropriate
skin care following each episode .
WARNING
• It is the responsibility of the caregiver to monitor the
patient's condition at regular intervals to ensure patient
safety .
• Disinfect the support surface between patients . Failure
to properly disinfect could result in cross-contamination
and infection .
• Consult physician if redness or skin breakdown occurs .
Return To Table of Contents
1-36
Nursing Care
1-26) to roll the patient onto their side .
1-26) to roll the patient onto their side .
2950-109-005 REV B www.stryker.com