3.12 A
CCESS CODES FOR TECHNICAL INFORMATION
3.12 Access codes for technical information
In order to perform periodic maintenance
properly, the actual operating hours of the
equipment must be known. This number can
be shown on the display with an access code
or password.
While the equipment is in Standby,
simultaneously press 3 1 4 on the number
pad. The display will show:
PASSWORD = 0
key in the password code 1508 and press
ENTER.
The following messages will appear:
HOURS ON = 1512
indicates the total number of hours the
equipment has been turned on.
Press the ENTER key to continue:
HOURS OF USE = 342
indicates the number of hours of operation
of the equipment.
Press the ENTER key to continue.
After this last message, the equipment returns
to Standby.
69