Installation On The Profile Slot; Connecting The Controllers/Hand Switches - RK Multilift I Mono Montageanleitung

7. Life phases

7.4.3 Installation on the profile slot

For assembly, proceed as follows:
Swivel the slot stone -RF- (included in the scope of delivery) into the profile slot.
If desired, push the cover profile (included in the scope of delivery) into the profile slot. The profile
must be shortened if necessary.
When fastening the respective components, it is vital that the recommended minimum screw-in
depth and the recommended tightening torque are observed.

7.5 Connecting the controllers/hand switches

The following external controls can be connected to the allocated lifting columns:
Controls
RKMultiControl Care mono
RKMultiControl Care synchro
RKMultiControl mono
MultiControl mono accu
RKMultiControl duo
MultiControl duo silent
MultiControl duo accu
RKMultiControl quadro
Compact-e-3-EU
Transformer controller 120 VA
MultiControl II duo
The controls listed here do not have an emergency stop switch. To move the lifting columns, the
corresponding button on operating part of the control must be continuously pressed. In an
emergency, the lifting columns can be brought to a stop by pulling the mains plug or the cable to
the lifting column.
72
Cover profile
Slot stone -RF-
Multilift I
Mono
x
x
x
x
x
Multilift I Product line
Synchro Multilift II
x with adapter
x
x
x
x
with adapter
cable
x
X