ECOLAB ELADOS Pump Rack Betriebsanleitung Seite 178

Decommissioning / dismantling / environmental protection
NOTICE!
Material damage by using incorrect tools!
Material damage may arise by using incorrect tools. Use the correct tools.
The procedure for dismantling is as follows:
1.
Make sure you have sufficient space before starting all tasks.
2.
Drain operating fluids and consumables and remove the remaining processing
materials; dispose of them in an environmentally-friendly way.
3.
Clean assemblies and components properly and disassemble them in compliance
with applicable local occupational health and safety and environmental protection
regulations.
4.
Always handle open, sharp-edged components carefully.
5.
Keep the workplace tidy and clean. Loose components and tools lying on top of or
around each other are sources of accidents.
6.
Depressurise the system and pressure line.
7.
Dismantle components properly.
8.
Observe the heavy weight of some components. If required, use lifting gear.
9.
Support the components to avoid them falling or tipping.
NOTICE!
In case of doubt, always consult the
on page 15 .
417102267 Ver. 04-11.2023
Ä Chapter 1.6 'Manufacturer'
84