Hazardous Areas On The Equipment - Ecolab Elados Pump Rack Betriebsanleitung

Safety
Hazard arising from automatic start-up
DANGER!
Automatic start-up poses a hazard in areas marked with the symbol opposite.
An automatic start-up can be initiated as soon as the power supply is
connected with no need to press a switch/button beforehand.
Hazards caused by pressurised components
DANGER!
Danger of injury from pressurised components!
With improper handling, pressurised components can move uncontrollably and
cause severe injuries.
Liquid under high pressure can escape from pressurised components if
handled improperly or in the case of a defect. This can lead to severe or fatal
injuries.
– Take appropriate protective measures during operation, e.g. by using
splash protection covers.
– Establish a pressure-free state.
– Discharge any residual energy.
– Make sure that liquids cannot be discharged accidentally.
– Immediately call in qualified staff to replace defective components which
are pressurised during operation.
2.8.1

Hazardous areas on the equipment

The areas around the system and the control unit are defined as the "operating area" for
the operating personnel.
When performing equipping, cleaning, maintenance and repair works the area around the
equipment or the individual equipment components is an area of risk and may only be
accessed by specialist personnel whilst observing the safety regulations.
WARNING!
– The hazard area extends to 1 m around the machine or installation during
equipping, maintenance and repair works.
– All for the swing area of installation doors as they open.
– The owner/operator has to ensure that entering the hazard area during
movement processes is prevented.
DANGER!
Unauthorised access
The owner must ensure that unauthorised personnel are prevented from
accessing the operating area.
417102267 Ver. 04-11.2023 26