Emergency Stop Switch; 5.7.12.1 Assembling The Emergency Stop Switch - Ecolab Elados Pump Rack Betriebsanleitung

Installation
5.7.12

Emergency stop switch

CAUTION!
The emergency stop switch must be accessible; it may not be blocked or
closed off!
DANGER!
Test the function of the emergency stop switch during commissioning! A
malfunctioning emergency stop switch can cause serious damage.
Figure

5.7.12.1 Assembling the emergency stop switch

Fig. 18: Assembling the emergency stop switch
1 Emergency stop switch
2 Screws (4 x)
1.
Screw the emergency stop switch (item 1) using four screws (item 2) onto the
mounting bracket (item 3).
2.
Use screws ( item 4) to fasten it to the left or right outside of the Pump Rack stand.
3.
Open the switch housing.
4.
Wire the switch to the control unit according to the wiring diagram.
5.
Close the switch housing.
6.
Test its function during commissioning.
417102267 Ver. 04-11.2023
Designation
Emergency stop switch
3 Mounting bracket
4 Screws (2 x)
60
Article no. EBS No.
201546 10026016