ECOLAB ELADOS Pump Rack Betriebsanleitung Seite 158

Installation
5.8.2 Assembly of strain relief for suction hose in dimensions 15.9 / 22.3
Fig. 20: Assembly of strain relief for suction hose
1 a Cable connections
1b Cable gland (removed for assembly)
2 Guide bar
3 Tygon hose 15.9/22.3
4 Suction lance
1.
Remove cable gland (item 1b) from guide rail (item 2) (item 1b).
2.
Connect suction hose (item 3) to suction lance (item 4) and fasten with a hose clip
(item 5a).
3.
Guide the suction hose (item 3) from below through the hole in the guide rail (item 2).
4.
Thread the disc (item 6) and hose clamp (item 5b) onto the suction hose (item 3).
5.
Connect the hose (item 3) to the hose nozzle (item 7) of the metering pump (item 8)
and fasten with a further hose clip (item 5c).
6.
Push the previously threaded hose clamp (item 5b) and washer (item 6) down to the
stop on the guide rail (item 2) and tighten.
417102267 Ver. 04-11.2023
5a, 5b, 5c Hose clamp
6 Washer
7 Hose connector
8 Metering pump
64