Installation Prerequisites - Ecolab Elados Pump Rack Betriebsanleitung

CAUTION!
Protection against a backflow of non-potable water must be present in the
supply line in accordance with EN1717 (BA type backflow preventer).
The standard scope of delivery does not include components related to
this.
If no safeguard installed by the owner, a separately available backflow
preventer must be installed upstream. For further info, see:
9.1 'Optional ELADOS Pump Rack equipment' on page 71
The system must not be operated without some type of backflow
safeguard in place!
Check all the connections for leaks before commissioning the pump!
5.2

Installation prerequisites

1.
Make sure there is enough space for wall mounting.
2.
For safety reasons, the Pump Rack must be attached to a suitable wall using the
enclosed fastening material (wall plugs and screws).
3.
Observe the requirements for the fresh water connection.
CAUTION!
The Pump Rack must be installed immediately next to the
"MyControl" unit.
If this is not possible, an optional emergency stop switch, which is to
be connected to MyControl, must be mounted outside the Pump Rack
bracket, either on the left or right (
(specimen view)' on page 34 , Fig. 4 , item A).
The mounting holes required are already in place. Alternatively, a suitable
position in the vicinity of the rack can be used (adjacent side wall, etc.).
If there is no protection against the backflow of non-drinking water
into drinking water pipes installed by the customer in accordance
with EN ISO 1717, this must be installed before the system is put
into operation.
A corresponding unit is available as an option.
Prevent equipment faults by providing a mud guard upstream. A
shut-off tap is also recommended to be able to depressurise the
device for maintenance purposes.
Ä Chapter 4.2 'Structure drawing
43
Installation
Ä Chapter
417102267 Ver. 04-11.2023