Assembling The Pump Connection Kit Turbopump; 3-Way Ball Valve With Product Sampling Option - Ecolab Elados Pump Rack Betriebsanleitung

5.7.3

Assembling the pump connection kit TurboPump

Fig. 10: Assembling the pump connection kit TurboPump
1.
Assemble the hose nozzle (item 1) with the O-ring (item 2) and union nut (item 3)
on the suction side pump connection. Assemble the pump connection.
2.
Push on the Tygon hose (item 6) and fix in place with the hose clamp (item 4).
3.
Assemble the threaded sleeve (item 5) with the pre-assembled male stud coupling
and O-ring (item 2) on the pressure-side pump connection.
4.
Cut off the PEX or PTFE pipe (no. 7) at right angles and slightly chamfer the inner
edge.
5.
Push the PEX or PTFE pipe (item 7) over the threaded piece (item 8) as far as it will
go.
6.
Push on the clamping ring (item 9).
7.
Screw in the union net (item 10).
5.7.4

3-way ball valve with product sampling option

Figure
CAUTION!
Counter the male stud coupling with a flat spanner at the same time to
avoid exceeding the permissible tightening torque!
Check the connections for leaks when commissioning the pump!
Designation Material
PP/EPDM
Product sampling
PVDF/FPM
valve (pre-
assembled)
PP/EPDM
PVDF/FPM
Connection Misuse
Alkaline
products
8 / 12
Acidic products
Alkaline
products
12 / 16
Acidic products
49
Installation
Article no. EBS No.
201527 10025973
201529 10025971
201530 10025970
201538 10025938
417102267 Ver. 04-11.2023