Supply Circuit Disconnect / Master Switch; Emergency Stop Button; Control And Software - Ecolab Elados Pump Rack Betriebsanleitung

Safety
2.10

Supply circuit disconnect / master switch

A master switch is contained in the "MyControl" unit approved by Ecolab.
In case the master switch cannot be mounted directly next to the device, a separate
master switch must be installed.
When the master switch is actuated the equipment is connected to the power supply or is
disconnected from the power supply. The master switch is located in the electrical cabinet.
DANGER!
When the master switch is switched off due to cleaning, maintenance or repair
work being performed, it is to be secured to prevent it being switched on again.
2.10.1

Emergency stop button

Fig. 2: Emergency stop button
When the emergency stop button is actuated, the system is immediately transferred into
safe operating mode.
For safety reasons, in cases where the control unit (e.g. "MyControl") cannot be installed
in the immediate vicinity of the Turbo Compact 2, an emergency stop button must be
installed at a suitable position.
WARNING!
The master switch may only be actuated/unlocked when the cause of the
EMERGENCY shutdown has been clarified and rectified.
The system must then be started up again.
2.11

Control and software

CAUTION!
– The system may only be operated by specialist personnel who are qualified
and trained!
– Only use an Ecolab-approved control unit, for example "MyControl" in order
to disable the rack immediately in the event of a malfunction.
417102267 Ver. 04-11.2023 28