Assembling The Flushing Extension; Manifold Connection - Ecolab Elados Pump Rack Betriebsanleitung

Installation
5.7.6

Assembling the flushing extension

1.
Isolate the unit from the mains.
2.
Interrupt the fresh water supply.
3.
Loosen the fastening screws on both sides (4 x, Fig. 12 , No. 14) on the fastening
brackets (2 x, Fig. 12 , No. 11).
4.
Remove valve block with spacers.
5.
Loosen end piece ( Fig. 12 , item 12) and pull off.
6.
Fit the flushing extension onto the valve block and push it on until it latches into
position.
7.
Push on the end piece again.
8.
Fasten the valve block with spacers.
9.
Route the coil cable to the terminal box, trim if necessary and isolate the wires.
10. Connect the cable to the terminal box.
11. Put the ELADOS Pump Rack back into operation.
12. Check the valve black for correct functioning.
5.7.7

Manifold connection

Figure Designation
Suction valve
SAV PPEPKE007
G5/8-G5/8-99
Threaded socket
G1/2i G5/8i PP
Male stud coupling
G1/2 8/12 PP
Suction valve
SAV PVFPKE007
G5/8-G5/8-99
Threaded socket
G1/2i G5/8i PVDF
Male stud coupling
G1/2 8/12 PVDF
417102267 Ver. 04-11.2023
CAUTION!
Check that the O-rings are seated correctly.
Misuse
Alcaline
products
Acidic
products
Material Connection Article no. EBS No.
PP 8 / 12
PVDF 8 / 12
52
249477 10200140
30190706 10032390
415102370 10022775
249326 10200137
30190707 10032391
415102371 10022785