Operation; Requirements For Operation - Ecolab Elados Pump Rack Betriebsanleitung

Operation

7 Operation
Personnel:
Safe, trouble-free operation can only be guaranteed in combination with an Ecolab
control system specially tailored to the unit (including an evaluation of all installed safety
equipment). We urgently advise that you do not use other companies' control systems as
there is no guarantee that the unit will function smoothly and, in particular, that the safety
components can be implemented.
The ELADOS Pump Rack is commissioned using the "MyControl" unit.
Note for operation:
Ä Chapter 4.5 'Control unit – MyControl' on page 38
7.1

Requirements for operation

NOTICE!
The Pump Rack may only be operated with the MyControl unit adapted to the
device or with a control unit approved by Ecolab.
The documentation provided with the controller must be used for the operation
and connection of the controller.
CAUTION!
The device may only be operated with the included splash guards in place.
Operation without splash guards is prohibited.
After completing maintenance work, then re-install the splash guards and cover
plates and check for integrity.
The device must be visually inspected at regular intervals to identify leaking components
at an early stage and thus avoid more serious damage.
Particular attention should be paid to the sump.
If there is any product or water in the sump, this indicates that there is a leak or that the
multifunctional valve (safety valve) has responded.
The cause of the fault must be found, rectified, and then the sump must be thoroughly
cleaned.
417102267 Ver. 04-11.2023
n Operator
n Specialist
68