Pump Assembly - Ecolab Elados Pump Rack Betriebsanleitung

Installation
5.6

Pump assembly

CAUTION!
After installing the pump, it is essential to check that it is securely held.
Assembly of the TurboPump
Fig. 6: Assembly TurboPump
1 Screws M 5 x 45 mm
2 Screws M 4 x 16 mm
1.
Fasten both terminal blocks (no. 4) with 2 screws each 4 x 16 (no. 2).
2.
Place the pump on the stand.
3.
Snap a terminal block (item 4) with protruding screws (item 2) into the two rear foot
drill holes in the pump.
4.
Screw the terminal block (item 4) into the threaded holes provided in the stand with
two screws M 5 x 45 (item 1) and washers (item 3).
5.
Install the second terminal block (item 4) in the same way.
Assembly EMP III pump:
Fig. 7: Assembly EMP III pump
1.
Place the pump on the stand.
2.
Screw it into the threaded holes provided in the stand with four screws M 6 x 40
(item 1) and washers (item 2) and tighten it.
417102267 Ver. 04-11.2023
3 Washers
4 Terminal blocks
1 Screws M 6 x 40 mm
2 Washers
46