Angelo Po FX61G 3-3R Bedien- Und Installationshandbuch Seite 168

CONNECTING THE BURNT GAS EXHAUST VENT
Important
Make the connection in compliance with the relevant legal requirements, using
appropriate and recommended materials.
Important
The maximum exhaust gas temperature at the outlet is about 400 °C.
Connecting to a fan extractor hood
Position the appliance underneath the hood (C) as
shown in the diagram.
Important
The gas supply tap must open automatically
when the fan of the extraction system is switched
on.
CONVERSION OF GAS SUPPLY
The Manufacturer has tested the appliance with its own mains gas, identified by the
sticker applied to the nameplate.
If the type of gas to be connected is different from
that used for testing, proceed as follows.
IT
1 – Turn off the gas supply tap (A).
2 – Change the burner nozzle (see page 81).
GB
3 – Remove the testing gas sticker from the dataplate
(B) and apply the new one to identify the gas being
DE
used.
4 – Remove the sticker from the appliance and apply
FR
the new one (C) with the category of the country of in-
stallation.
ES
5 – Access the "Service" menu and activate the "Gas
type conversion" procedure (see page 78).
6 – Carry out the appliance testing procedure (see
page 79).
Important
On completion of the operation, make sure that
there are no gas leaks or malfunctions.
English
C
min
0,3m
- 78 -
IDM-39619300700.tif
Use and installation manual