Angelo Po FX61G 3-3R Bedien- Und Installationshandbuch Seite 159

Alarm Fault
Maximum allowed temperature
E09 in chamber exceeded
Electrical component compart-
E10 ment has overheated
E11 Electronic circuit board diag-
E13 nostics tripped
E14
The humidity probe has failed or
E19 is not properly connected
Setup error
E20
The washing cycle has been in-
terrupted because there is no
cleaner
E21
The washing cycle has been in-
terrupted because there is no
sanitizing cleaner
E22
The washing cycle has been in-
terrupted during the final saniti-
zation stage
E23
Automatic cleaning system fail-
ure
E24
E26
System filling procedure not
completed
E25
Failure test gas
E27
E28 Valve has failed to close/open. Press the "Reset" button
English
Remedy
Inform the after-sales service
The oven solves the problem on
its own
Inform the after-sales service
Inform the after-sales service
Inform the after-sales service
Check the pipe position and the
level of cleaner in the tank; top
up if necessary and restart the
washing cycle.
If it is not possible to complete
the cleaning operation, perform
an emergency rinse or rinse the
cooking chamber by hand
Check the pipe position and the
level of sanitizing cleaner in the
tank; top up if necessary and re-
start the washing cycle
If it is not possible to complete
the cleaning operation, perform
an emergency rinse or rinse the
cooking chamber by hand
Press the reset button and rinse
the cooking chamber thorough-
ly by hand.
Operate the oven in convection
mode to dry the cooking cham-
ber.
Check that no residues of clean-
ing products have been left in-
side the cooking chamber.
Rinse the cooking chamber by
hand.
Check the position of the pipe
and the level of the sanitizer in
the container; if necessary, top
it up and re-launch the automat-
ic cleaning cycle.
Inform the after-sales service
- 69 -
Notes
The oven's functions are dis-
abled so no cooking cycles
can be carried out
The oven's functions are en-
abled so cooking cycles can
be carried out
The oven's functions are dis-
abled so no cooking cycles
can be carried out
The oven's functions are en-
abled so cooking cycles can
be carried out
The oven's functions are dis-
abled so no cooking cycles
can be carried out
If the problem persists, call
the after-sales service
If the problem persists, call
the after-sales service
If the problem persists, call
the after-sales service
If the problem persists, call
the after-sales service
The oven's functions are en-
abled so cooking cycles can
be carried out
If the problem persists, call
the after-sales service
The oven's functions are en-
abled so cooking cycles can
be carried out
Inform the after-sales service
Use and installation manual
IT
GB
DE
FR
ES