Herunterladen Diese Seite drucken

Scheppach SC2200PE Original Bedienungsanleitung Seite 45

Vorschau ausblenden Andere Handbücher für SC2200PE:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Removing the battery before disposing of the de-
vice
• The integrated battery must be removed and dis-
posed of separately in an environmentally friendly
manner before disposing of the device.
• Mask off the contacts and package the battery such
that it cannot move in the packaging. Please also
observe any further national regulations.
16. Troubleshooting
Fault
Possible cause
Engine does not start
Spark plug connector unplugged.
Contaminated spark plug.
No fuel or old fuel.
Choke not in open position.
Fuel line clogged.
Engine dies.
Motor runs erratically
Spark plug connector loose.
Fuel line clogged or old fuel.
Ventilation blocked
Water or contamination in the fuel
system
Incorrect carburettor setting
Motor is overheated
Engine oil level low.
Contaminated air filter.
Airflow restricted.
Carburettor not adjusted correctly.
The machine does
The gear was not chosen correctly. Shift the shift lever to the correct shift position.
not move when the
engine is running
The machine does not
Varying tyre pressure
run straight
Engine does not start
Battery has discharged.
with electric starter
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
electrical devices.
Fuels and oils
• Before disposing of the unit, the fuel tank and the
engine oil tank must be emptied!
• Fuel and engine oil do not belong in household
waste or drains, but must be collected or disposed
of separately!
• Empty oil and fuel tanks must be disposed of in an
environmentally friendly manner.
Remedy
Re-connect the spark plug cable to the spark plug.
Clean, set gap or replace.
Fill with clean, fresh petrol.
The choke lever must be positioned in the choke
position during cold starting.
Check the fuel line for kinks or damage.
Wait a few minutes before restarting.
Connect and fasten the spark plug cable.
Fill the tank with clean, fresh petrol.
Clean the air filter.
Empty the tank. Fill the tank with fresh fuel.
Contact the service department.
Top up the oil.
Clean or replace the air filter.
Remove and clean the housing.
Contact the service department.
Check the tyre pressure.
Charge the battery for min. 5 hours.
www.scheppach.com
GB | 45

Werbung

loading

Diese Anleitung auch für:

5908703903