Sachs Bikes MadAss Reparaturanleitung Seite 63

LUBRICATION SYSTEM
Install the pump cover gasket (1) and measure the pump end
clearance.
SERVICE LIMIT: 0.27 mm (0.011 in)
1
ASSEMBLY
Install the outer rotor (2) and inner rotor (3).
B
2
Install the pump shaft (4) by aligning the fl at (A) on the shaft
with the fl at (B) on the inner rotor.
3
A
4
Install a new cover gasket (5) and the pump cover (6).
Secure the cover with the three screws (7) and make sure that
the oil pump turns freely without binding. 7
5
6
INSTALLATION
Set the shaft collar (1) into the right crankcase. 5
Install a new oil pump gasket (2) and set the oil pump (3) onto
the right crankcase by aligning the groove of the rotor shaft (4)
with the cam chain guide spindle (5).
1
Tighten the oil pump mounting screws very securely. Check the
cover screws for loose, retighten them if necessary.
4
Install the clutch assembly.
Install the removed parts in the reverse order of removal. Fill
the engine with recommended oil.
2
3
60