ELECTRICAL SYSTEM
Adjusting the headlamps
WARNING
Do not run the engine in an enclosed space (risk of asphyxi-
ation).
Position the motorcycle on a level fl oor 5 m (measured from the
headlamp) from a light coloured wall with a rider seated on the
motorcycle and the tyres fi lled at the correct pressure.
- Measure the distance from the fl oor to the centre of the head-
lamp and mark the height on the wall with a cross. Draw a
second cross 12 cm beneath the fi rst cross.
- Start the motorcycle and run the en gine.
- Activate the dipped beam.
- Use the adjusting screw (1 and 2) on both sides to adjust
the angle of the asymmetrically illuminated surface area of
the road top.
- Release screws (1) and (2), adjust and tighten up.
186
H
5m
H
2
1