Sachs Bikes MadAss Reparaturanleitung Seite 199

IGNITION SYSTEM
ALTERNATOR
(Exciter coil)
Disconnect the alternator wire connector.
Measure the resistance between the Black/Red and ground.
RESISTANCE: circa 550 Ω
If the resistance is out of specifi cation replace the alternator.
PULSE GENERATOR (PICKUP)
Remove the battery cover and the battery.
Disconnect the alternator 6- pole connector and measure the
resistance between the blue/white wire terminal and ground.
RESISTANCE: circa 150 Ω
If the resistance is out of the specifi cation, replace the
alter nator.
IGNITION TIMING INSPECTION
NOTE
The Capacitive Discharge Ignition (CDI) system is factory pre-
set and does not require adjustment. To inspect the function of
the CDI components, ignition timing inspection procedures are
given here.
Remove the left crankcase cover.
Connect a tachometer and timing light.
Start the engine and allow it to idle.
IDLE SPEED: 1.800 +/- 200 rpm
Inspect the ignition timing
Timing is correct, if the "F" mark on the fl ywheel is aligned with
the index mark on the left crankcase at idle.
(1) INDEX MARK
(2) "F" MARK
196