Engine Oil; Engine Oil Fi Lter Cleaning - Sachs Bikes MadAss Reparaturanleitung

LUBRICATION SYSTEM

ENGINE OIL

1
OIL LEVEL CHECK
Support the motorcycle upright on level ground.
Check the oil level with the fi ller cap/ dipstick (1).
CAUTION
For checking the oil level only insert the oil fi ller cap and
don't screw in!
Otherwise there will be a wrong measurement in order to
avoid engine damage.
If the level is below the lower level mark (4) on the dipstick, add
the recommended oil to the upper level mark (3).
2
SFM 649 007.3
OIL CHANGE
NOTE
Change the engine oil with the engine warm to ensure complete
and rapid draining.
Remove the oil fi ller cap/ dipstick.
Place an oil drain pan under the engine, and remove the drain
bolt (2) and drain the engine oil.
Make sure that the sealing washer is in good condition and
install the drain bolt.
TORQUE: 25 Nm
3 UPPER
Fill the crankcase with the recommended oil.
4 LOWER
CAPACITY: 0.8 litres at oil change
SFM 649 008.3
Install the oil fi ller cap/ dipstick. Start the engine and let it idle
1
for 2-3 minutes.
WARNING
If the engine must be running to do some work, make
sure the area is well-ventilated. Never run the engine in
an enclosed area. The exhaust contains poisonous carbon
monoxide gas that may cause lass of consciousness and
lead to death.
Stop the engine and check that the oil level is at the upper level
mark on the dipstick with the motorcycle upright. Make sure
there are no oil leaks.
ENGINE OIL FILTER CLEANING
NOTE
2
Drain the engine oil before cleaning the fi lter.
Remove the right crankcase cover (1).
Remove the clutch outer cover (2).
Clean the clutch outer cover and inside of the clutch outer using
a clean lint-free cloth.
NOTE
Do not allow dust and or dirt to enter the crankshaft oil
passage.
Do not use compressed air.
54