Carburetor Idle Speed - Sachs Bikes MadAss Reparaturanleitung

MAINTENANCE
Adjust by loosening the lock nut and turning the adjusting screw
until there is slight drag on the feeler gauge. Hold the adjusting
screw and tighten the lock nut. Recheck the valve clearances.
(1) VALVE ADJUSTER B
TOOLS:
Valve adjust wrench, 9 mm
Valve adjuster B P00 927 941 92 12 000
Install the valve adjuster covers and the inspection plugs.
(2) VALVE ADJUST WRENCH 8x9 mm

CARBURETOR IDLE SPEED

NOTE
Inspect and adjust the idle speed after all other engine
maintenance items have been performed and are within
specifi cations.
(1) THROTTLE STOP SCREW
The engine must be warm for accurate idle speed inspection
and adjustment.
Shift the transmission into neutral and place the motorcycle on
its center stand on level ground.
Warm up the engine for about ten minutes and connect a
tachometer.
WARNING
If the engine must be running to do some work, make
sure the area is well-ventilated. Never run the engine in
an enclosed area. The exhaust contains poisonous carbon
monoxide gas that may cause lass of consciousness and
lead to death.
Turn the throttle stop screw as required to obtain the specifi ed
idle speed.
IDLE SPEED: 1.800 +/- 200 rpm
28