Adjusting The Clutch Lever Play - Sachs Bikes MadAss Reparaturanleitung

MAINTENANCE

Adjusting the clutch lever play

CAUTION
If you drive with no clutch lever play, the clutch will be
damaged.
Check:
- Pull the lever until there is discernable resistance.
- Measure the play. Required value:
Standard: A = min. 3-4 mm
Adjustment:
- Push back protective cap (1).
- Release the lock nut (2).
- Turn setting screw (3) as appropriate.
- Tighten up the lock nut (2).
- Check the play.
NOTE
If the clutch play cannot be corrected with this adjustment, the
following adjustment must be made.
- Release the lock nut (2).
- Tighten setting screw (3) all the way, so that the clutch cable
can be made as slack as possible.
- Tighten up the lock nut (2).
- Remove screws (4) and take off the clutch cover (5).
- Release the lock nut (6).
- Adjust the setting screw (7) until the desired clutch lever play
(A = 3-4 mm) is reached.
- Tighten up the lock nut (6).
- Reassemble the clutch cover (5) with gasket.
32
1
2
3
A
5
4
7 6
4