Sachs Bikes MadAss Reparaturanleitung Seite 105

CYLINDER HEAD / VALVES
CYLINDER HEAD INSTALLATION
Clean the cylinder head gasket surface of any gasket material.
NOTE
Do not allow dust and dirt to enter the cylinder.
Install the dowel pins, a new cylinder head gasket, the 0-rings
and collars.
Install the cylinder head and a new head cover gasket.
Position the cylinder head cover with its arrow (1) facing the
exhaust side.
4
Install the sealing washer (2), copper washer (3) and nuts (4) 4
in the proper locations.
2
2
Tighten the cap nuts to the specifi ed torque.
TORQUE: 10-12 Nm
1
2
3
4
4
Install the muffl er in the reverse order of removal.
TORQUE
2
Exhaust pipe joint nuts (1): 10-12 Nm
Tighten the intake manifold bolts (2).
TORQUE: 10 Nm
NOTE
Make sure that the O-ring is positioned properly.
1
102