Skin Preparation; Emc Compliance; Fcc And Industry Canada Compliance Statement - Eko DUO Benutzerhandbuch

1.6 Skin Preparation

Excessive hair, dirty skin, dry skin, or oily skin can
impact the quality of the ECG tracing. Clean the
patient's skin with water and soap and remove
excess hair as needed to achieve the highest quality
tracing. Do not use DUO over wound areas or
areas of broken skin. Do not use an alcohol based
skin cleaner as this dries out the patient's skin and
increases resistance. Rub the skin vigorously to
increase capillary blood flow to the tissues.
ECG gels or saline solutions can be used on the
electrodes to improve signal quality.

1.7 EMC Compliance

FCC Intentional Radiator Certification
Eko DUO:
FCC ID: 2ANB3-DUO
IC: 23063-DUO
MIC ID: 020-210076
Wireless Touch Charging Pad:
FCC ID: 2ANB3-W1
This equipment is approved by the FCC under the
FCC ID numbers shown above. This device complies
with Part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device
must accept any interference received, including
interference that may cause undesirable operation.
NO MODIFICATION: Modifications to this device
shall not be made without the written consent of Eko
Devices, Inc. Unauthorized modifications may void
the authority granted under Federal Communications
Commission rules permitting the operation of this
device.
EMC Compliance Europe
This equipment complies with the EMC requirements
of the IEC 60601-1-2.
DUO - User Manual Pg 5
1.8 FCC and Industry Canada
Compliance Statement
This device complies with FCC Rules Part 15 and with
Industry Canada license-exempt RSS standard(s).
Operation is subject to two conditions: (1) This device
may not cause harmful interference, and (2) this
device must accept any interference that may be
received or that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil
doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.