General User Code For Output #1 - Programming Code 03 - Sygonix 2365006 Bedienungsanleitung

f) General user code for output #1 - programming code 03
The general user code is the code for mode 4 "Transponder card + general user code" (see
Chapter 12. b). It applies to all transponder cards. The code can never be used alone, but only
in combination with a transponder card. The code lock requires both card and general user code
to grant access.
Save general user code:
• The code lock should be in programming mode, see Chapter 14. b).
• Enter programming code
• Enter a 4 to 8 digit general user code (e.g.
Important!
If you activate the automatic access mode (see Chapter 14. m), all codes should have
the same length (such as master code + superuser code + user codes 5 digits).
• Press the button to confirm your entry.
• The code lock emits two beep tones and the centre LED flashes twice orange. The general
user code is saved.
If a new general user code is programmed, it overwrites the previous code.
Delete general user code:
• The code lock should be in programming mode, see Chapter 14. b).
• Enter programming code
• Press the button to confirm your entry.
• The code lock emits two beep tones and the centre LED flashes twice orange. The general
user code is deleted.
.
.
).
85