Herunterladen Inhalt Inhalt Diese Seite drucken

Example; Configuring The Settings - Sygonix 2365006 Bedienungsanleitung

Wi-fi codeschloss, ip55
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

15. Example

For easier understanding, we would like to give you a programming example in this chapter. The
following specifications are to apply in this example:
• Two persons are to gain access to a building via one transponder card each by activating
the door opener via output #1. The time delay for activating the door opener connected to
output #1 is 3 seconds.
• Two further persons shall be granted access to a building via different user codes by
activating the door opener via output #1.
• In addition, two other persons shall have access to a building via a transponder card with a
secondary user code (both users shall use the same secondary user code) by activating the
door opener via output #1.
• Since the automatic access mode is not to be used (default setting on delivery; see Chapter
14. m), the master code and the user code can have a different code length (4 to 8 digits).
a) Configuring the settings
Step 1: Turn on the power supply
If you have not already done so, connect the code lock to the power supply. Wait 1 minute until
the code lock is in normal mode. The centre LED flashes slowly orange. The code lock is ready.
Step 2: Enter the master code
• Enter the master code and press the star button.
By default, the master code is set to "0000". If you have set a different master code,
enter the existing code (not 0000).
• The code lock emits two beep tones and the centre LED at the top of the code lock lights up
permanently orange and flashes red at the same time. The programming mode is activated.
109

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis