Activating/Deactivating Flashing Signal In Normal Mode - Programming Code 73 - Sygonix 2365006 Bedienungsanleitung

p) Activating/deactivating flashing signal in normal mode -
programming code 73
In standby mode, the code lock waits for the user code to be entered or for a signal from
a transponder. The centre LED flashes orange once every second. This flashing signal also
serves to check the function of the code lock.
This LED indicator can be turned on or off as desired. However, this does not apply to the
flashing signals that indicate the system status.
Switching the flashing signal on/off during normal mode:
• The code lock should be in programming mode, see Chapter 14. b).
• General input for programming:
Programming code
• Programming code 73
• Mode selection:
Flashing signal is switched off
Flashing signal is switched on (default setting)
• Confirmation:
Press the button to confirm your entry.
The code lock emits two beep tones and the centre LED flashes twice orange. Programming
is saved.
• When you have finished programming, exit programming mode with the
Mode selection
or
Confirmation
button.
105