F) Saving A User Code - Sygonix 1717531 Bedienungsanleitung

f) Saving a user code

The code lock has a total of 1000 storage devices. Either a user code, a transponder or a
combination of both can be stored therein depending on the operating mode (see chapter 9. c).
To save a transponder or the combination of the user code and the transponder, see chapter
9. i).
We recommend that you create a table and precisely record all access data (memory
number, user code/transponder, user name). This is the only way to get an overview
of who has tuned in to the code lock.
In addition, it is very easy to change or delete a user and its access authorisation (user
code and/or transponder) as needed.
Saving a user code:
• Enable the programming mode; see chapter 9. a).
• Enter . The control LED will flash yellow.
• Enter . The code lock will emit a long sound signal and the control LED will glow
yellow steadily.
• Enter a memory number (
• Enter the desired user code (the code length of the user code must match that of the master
code, e.g. 4 digits).
• The code lock will emit a short and a long sound signal and the control LED will glow yellow
steadily. The master code will be stored.
• Briefly press the
You can now save another user code, if desired. Proceed by entering the program-
ming code
• Press the button to exit programming mode. The control LED will glow red steadily.
Changing the user code:
Follow the same procedure as for saving the user code; see above. Select the memory number
that you want to change and enter the new user code.
42
.....
key.
as described above.
). The code lock will emit 2 sound signals.