User Codes/Transponder Cards For Output #1 - Programming Code 10 - Sygonix 2365006 Bedienungsanleitung

g) User codes/transponder cards for output #1 -
programming code 10
A total of 1000 storage locations are available for user codes and/or transponder cards, for
output #1.
We recommend that you create a table and record all access data accurately (user ID,
user code, user name, switching operation for output #1). This will help you to monitor
registered users and access permissions.
It will also make it easier to delete users and the corresponding user codes.
Save user code/transponder card :
• The code lock should be in programming mode, see Chapter 14. b).
• General input for programming user codes and/or transponder cards:
Program-
ming code
• Programming code 10
• Mode (Mode, see Chapter 12. b):
Transponder card only
User code only
Transponder card + secondary user code
Transponder card + general user code
Deleting a transponder card/user code of the selected user ID
The secondary user code can be an individual code, both for an individual or several
transponder cards. For example, it is possible for a department to use an individual
transponder card and the same secondary user code for each employee.
The general user code applies to all transponder cards. It must first be programmed
separately (see Chapter 14. f).
• User ID:
-
86
Mode
-
1000 user IDs for user codes and/or
transponder cards for output #1
User ID
-
Card/user code
Read card/enter
user code
Confirma-
tion