Programming The Master Code - Programming Code 01 - Sygonix 2365006 Bedienungsanleitung

• When deletion is finished, the code lock emits two beep tones and the centre LED at the top
of the code lock lights up permanently orange and flashes red at the same time. Programming
mode is now enabled.
• All settings and programmings have now been reset to the factory settings (except the master
code).
DAP code "2828" and reset code "9999" are permanently stored in the system. They
cannot be changed.
d) Programming the master code - programming code 01
Important!
If you activate the automatic access mode (see Chapter 14. m), all codes must have
the same length as (e.g. master code + superuser code + user codes 5 digits).
The master code can have 4 to 8 digits.
The master code is only used to activate the programming mode (see Chapter 14. b). It cannot
be used to activate any of the outputs.
Proceed as follows:
• The code lock should be in programming mode, see Chapter 14. b).
• Enter programming code
• Enter the new master code, e.g.
• Press the button to confirm your entry.
• The code lock emits two beep tones and the centre LED flashes twice orange; the new
master code is stored (the old one is overwritten).
Write down the new master code and store it in a safe place. If you have forgotten the
master code, proceed as described in Chapter 13 to start programming mode. Then
program a new master code.
82
.
.