Visitor Code For Output #1 - Programming Code 40 - Sygonix 2365006 Bedienungsanleitung

h) Visitor code for output #1 - programming code 40
Visitor codes are special access codes that can be assigned either as a single-use code or as a
code with a time limit. A total of 50 memories are available for different visitor codes.
• Single-use code: Output #1 will be activated when a valid visitor code is entered. The code
can only be used once.
• Code with a time limit: The visitor code can be used an unlimited number of times during
the specified time period (01–99 hours). After this period, the code automatically becomes
invalid.
For security reasons, all visitor codes are automatically deleted in the event of a power
cut.
Saving visitor codes:
• The code lock should be in programming mode, see Chapter 14. b).
• General input for programming visitor codes:
Program-
ming code
• Programming code 40
• Visitor ID:
-
• Validity period:
-
• Visitor code:
Enter the desired 4 - 8 digit visitor code.
If a new visitor code is saved for the visitor ID, the old code is replaced.
Visitor ID
-
50 visitor IDs for 50 visitor codes; all visitor IDs have two digits only.
Single-use code; has no time limit but can only be used once; it is
automatically deleted after use
Visitor code validity period in hours (1 to 99 hours);
the code is always entered with two digits;
the code is automatically deleted when the time limit is reached
Validity period
or
-
Visitor code
Enter visitor code
Confir-
mation
91