D) Programming The Master Code/User Code; E) Programming The Superuser Code - Sygonix 1559246 Bedienungsanleitung

d) Programming the master code/user code

The following section only applies to single user mode. For instructions on multi-user
mode (default mode), refer to section 12.
• The combination lock must be in programming mode (see section 12. a) for details).
• Enter the programming code:
Program the master code
Program the user code for output #1
Program the user code for output #2
• Enter the desired four-digit code.
In single-user mode, all codes must be four digits long. In single user mode, you can
only configure one user code for each output (as described in section 13).
• Press the button to confirm your entry. The combination lock will beep twice and the
middle LED will flash two times to indicate that the code has been saved (the old code will
be overwritten).

e) Programming the superuser code

To program the superuser code, follow the instructions in section 12. c). In single user mode, the
superuser code must be four digits long.
Saving the superuser code:
• The combination lock must be in programming mode (see section 12. a) for details).
• Enter programming code
• Enter the superuser code (e.g.
In single user mode, the superuser code must be four digits long.
• Press the button to confirm your entry.
• The combination lock will beep twice and the middle LED will flash two times to indicate that
the code has been saved (the old code will be overwritten).
106
.
).