Superuser Code - Programming Code 02 - Sygonix 2365006 Bedienungsanleitung

e) Superuser code - programming code 02
The superuser code is used to activate the outputs manually and it can activate or deactivate
all limitations of the outputs. It is completely independent of time restrictions or system locks.
The superuser code can also be used to permanently activate output #1 (and the connected
door opener).
Saving the superuser code:
• The code lock should be in programming mode, see Chapter 14. b).
• Enter programming code
• Enter a 4 to 8 digit code (e.g.
Important!
If you activate the automatic access mode (see Chapter 14. m), all codes should have
the same length (such as master code + superuser code + user codes 5 digits).
• Press the button to confirm your entry.
• The code lock emits two beep tones and the centre LED flashes twice orange. The superuser
code is stored.
If a new superuser code is programmed, it overwrites the previous code.
Deleting the superuser code:
• The code lock should be in programming mode, see Chapter 14. b).
• Enter programming code
• Press the button to confirm your entry.
• The code lock emits two beep tones and the centre LED flashes twice orange. The superuser
code is deleted.
Function 1: Activate/deactivate output #1
Enter the superuser code like a standard user code. The corresponding output is then activated
or deactivated (the superuser code also resets an activated output, e.g. if you have programmed
a very long activation period, see Chapter 14. i).
Example: The superuser code was set to "6789":
Function 2: Permanently enable output #1
Output #1 of the code lock is designed for a door opener. The superuser code can be used to
permanently enable/disable output #1 (i.e. door opener).
.
.
Enable/disable output #1
).
83