Battery Use And Charging; Replacing The Battery; Connecting The Beam Delivery Assembly - Chattanooga LIGHTFORCE FXi LTC-1510-L-B6 Gebrauchsanleitung

2.3.

Battery Use and Charging

Note: When the external power supply is connected to the laser system, the battery icon will blink green to indicate it is charging the battery.
To determine the battery charge level, the power supply must be unplugged from the rear of the device.
Warning:
• Do not modify the battery or attempt to insert foreign objects into it.
Do not short circuit the battery, keep away from metallic items.
•
Do not immerse the battery in water or get the battery wet.
•
Caution:
Use of this battery in other devices could result in damage to the device or battery.
•
The temperature range for charging this battery is 10 °C to 32 °C (50 °F to 90 °F). Do not charge the battery outside of this range.
•
• Do not store the battery at temperatures above 70 °C (158 °F), such as inside a car on a hot day or in direct sunlight; this may
damage the battery.
Avoid dropping the battery. If you suspect the battery or device is damaged, contact Customer Care.
•
• Do not disassemble, open, crush, bend, deform, puncture, shred or burn the battery.
When the laser system is turned on, there is a battery icon in the upper right corner of the display screen. The battery icon will indicate the amount
of charge in the battery when the laser system is not connected to AC power (mains/wall outlet). The icon will also change color from green to
amber to red as the charge is depleted. When the battery icon is red and blinking, the battery needs to be recharged.
2.4.

Replacing the Battery

Caution: Replace the battery only with an authorized replacement battery. These batteries have been tested in accordance with
applicable safety standards.
Warning: Discarded batteries may create a safety hazard. Before disposal, cover the battery contacts with electrical insulating tape.
If the battery is not charging as expected, contact Customer Care to go through troubleshooting to determine if a replacement battery is needed.
If the battery needs to be replaced, follow the steps below for removal and replacement of the battery.
Step 1. Turn the laser over and place it on a flat surface. Remove the battery cover by turning the finger locks. (Figure 9)
Step 2. To remove the old battery, grab the removal strap and pull straight up. (Figure 10)
Step 3. With the arrow on the battery pointing to the front of the unit (Figure 11), insert the new battery into the battery compartment.
Finger
locks
Step 4. With even pressure, fully seat the battery into the battery compartment.
Step 5. Replace the battery cover and secure the finger locks. The battery cover will fit tightly to hold the battery in place.
2.5.

Connecting the Beam Delivery Assembly

Caution:
Do not remove the hand piece fiber cable from the emission port once it has been secured (unless the optical fiber cable needs
•
to be replaced).
• Repeated insertion and removal of the hand piece fiber cable will increase the chance of emission port or fiber tip contamination.
If the emission port or the fiber tip is contaminated, the optical fiber can be damaged during laser emission.
If the fiber must be removed, use the dust cap to help prevent dust and debris from contaminating the emission port. Do not
•
leave the port unprotected.
Note: The laser system will be delivered with the optical fiber already connected. If it needs to be replacement, then follow Steps 1-6 to
disconnect the old and connect the new handpiece to the console.
Step 1. Unscrew metal fiber connector until loose and gently pull fiber away from unit Figure 12.
Step 2.
After removing fiber, unplug finger switch cord by pulling plug away from unit.
Step 3. Remove the new assembly from the protective foam packaging.
RSR-000886-000 (5)
Removal
strap
Figure 11 Figure 10 Figure 9
Figure 12
Page 5 of 20