Mounting The Wings - Reely Wild Hawk 3.0 Bedienungsanleitung

d) Mounting the wings
Connect the two wing servos (see lower picture in Figure
16) to a receiver output. For this purpose, use the Y-cable
(see Figure 2, no. 16).
As already mentioned in section 5, your model
may already come with the cable built into the
fuselage and connected to the receiver.
The cable has two sockets the plugs of the aileron servos
in the wings are connected to.
The Y-cable plug should subsequently be connected to the
receiver.
First plug in the wing connector (see also Figure 1, no. 6)
to the right wing half (2). Then insert the aileron servo plug
(3) into any Y-cable socket (4).
Make sure that the plugs are correctly aligned. The cables
must be connected as follows:
• White and orange
• Red and red
• Black and brown
Then push the plug into the wing groove (5).
After that push the right wing into the fuselage. While do-
ing so, make sure the servo cable sits neatly in the groove.
58
Figure 6