Mounting The Wings - Reely Piper J-3 Cub 2.0 Bedienungsanleitung

• In case of more pronounced wrong adjustments, the holding screw (11) of the respective servo lever can be un-
screwed, the servo lever removed upwards and after lobe-wise twisting screwed tight again.
Attention!
Ensure during this procedure that the receiver installation is switched off!
c) Mounting the wings
• Place the wings (1) onto the fuselage and slide the two
attachment bolts (see figure 6, pos. 5) carefully into the
prepared openings at the rear end of the fuselage cut-
out (2).
• Slide the wing backwards so that the front edge of the
wing connector (3) can be pushed downwards into the
wing cut-out.
• Align the surface at a right angle to the fuselage. The
two distances A must have the same length.
The wing tips must also have the same distance „B" to
the surface.
• Afterwards, attach the wing in the front with the two
2.5 x 24 mm screws (4) on the fuselage.
Attention!
Due to the fact that the wings are not sufficiently
stable at this point, you may not place the mod-
el on the back in the current state.
First you have to mount the wing struts (see
next chapter).
All manuals and user guides at all-guides.com
A
A=A
B=B
B
A
B
Figure 8
47